Home / Headphones / Headphone Test Online
HeadphonesHeadphone Test Online
Check both headphone drivers, confirm the left and right channels are not swapped, and sweep the full frequency range.
The online headphone test covers channel identification, channel swap, driver rattle and frequency response from 20 Hz to 18 kHz. Set your volume to about half before starting.
Headphone Test Online: the full method
- Set the volume to about half
Loud tones mask exactly the rattles and buzzes you are trying to find, and a full-volume sweep at 40 Hz can damage small drivers.
- Play the left channel
The left cell in the panel lights up. You should hear the tone only in your left ear. Nothing, or sound in the wrong ear, is a fault.
- Play the right channel
Same again on the right. If both sides play when only one should, the connection has fallen back to mono — common with a partly inserted 3.5 mm plug.
- Play both channels
A centred tone should appear to sit between your ears. If it pulls to one side, the two drivers are at different output levels.
- Run the frequency sweep
The sweep climbs from 20 Hz to 18 kHz over sixteen seconds. Listen for buzzing at the bottom, dropouts in the middle, and note where the tone disappears at the top.
- Try the individual tones
The tone buttons hold a steady pitch so you can compare ears carefully at a single frequency.
What each symptom means
- Buzzing on low tonesSomething is loose in the earcup, or the driver is damaged from prolonged high volume. Buzzing that changes when you press the cup is mechanical.
- Muffled on one sideEarwax or dust in the mesh. Clean the grille with a dry soft brush before assuming the driver has failed.
- One side silentTry a different port or device first. If it is still silent, the fault is in the cable or the driver — flexing the cable near the plug while a tone plays usually confirms a break.
- Channels swappedAlmost always an adapter or extension lead wired in reverse. A four-pole plug pushed into a three-pole socket produces the same effect.
What a channel swap really means
Swapped channels are almost never a fault in the headphones themselves. The usual causes are an extension lead or adapter wired in reverse, a four-pole plug pushed into a three-pole socket, or a balance control that has drifted in system settings.
It matters more than it sounds. Every stereo recording places instruments, voices and effects deliberately across the field, and reversing them scrambles that image. In gaming it is worse still, because directional audio cues point you the wrong way.
Frequently asked
Can this damage my headphones?
Not at moderate volume. Keep the level around half and avoid holding low-frequency tones at maximum output for long periods.
Do I need special headphones?
No. The test works with wired, USB and Bluetooth headphones, earbuds and over-ear models alike.
Does this test noise cancelling?
Not directly, but you can run the sweep with cancelling on and off and hear how the response changes.
What is a normal upper hearing limit?
Most people under 25 hear to about 17 kHz, most over 40 to around 14 kHz. Losing the top of the sweep is age, not equipment.
Related tests
Where to go next: testing AirPods, why AirPods sound worse on calls, or testing AirPods.
Tested and updated · Written and maintained by check-mic.com · Report a problem with this page