Home / Microphone test / Misc Test
Microphone testMisc Test
A live microphone test that runs entirely in your browser. Level meter, oscilloscope, spectrum, recorder and playback — no download, no account, nothing uploaded.
If you meant mic test, you are in the right place — this is a live microphone test. Press Start test, speak, and watch the meter respond.
Misc Test: step by step
- Pick the right input
Open the device list at the top of the console. Every microphone the system can see is listed by name. Choose the one you actually intend to use — the default is often a webcam or a virtual cable.
- Press Start test and allow access
The browser shows a permission prompt. Choose Allow. Nothing is recorded until you press Record, and even then the audio stays on your machine.
- Speak at your normal distance
Say a full sentence at conversational volume, sitting where you normally sit. The meter should swing between -24 dB and -6 dB. A flat meter means no signal is arriving.
- Check the waveform for damage
Open the Waveform panel. A healthy voice looks like rounded peaks with space above and below. Flat tops touching the edges mean the signal is clipping and words will sound crunchy.
- Record and play it back
Levels can look perfect while the audio sounds terrible. Record five seconds, play it back, and listen for hiss, hum, echo and keyboard noise.
- Read the report
The Report panel names the device, its sample rate and channel count, whether echo cancellation and auto gain are active, and gives a plain verdict you can copy into a support ticket.
If the meter does not move
- Something else has the microphoneZoom, Teams, Discord, OBS and Camera apps can hold an input exclusively. Quit them completely, including from the system tray, and try again.
- The operating system muted the inputOpen your sound settings and confirm the input volume is not at zero and the device is not disabled. A muted input produces a perfectly flat meter with no error message.
- The browser was never allowedClick the padlock or slider icon at the left of the address bar, set Microphone to Allow, then reload the page. A blocked prompt never appears twice on its own.
- The wrong device is selectedChange the input in the dropdown and the test restarts automatically. Laptops frequently default to a webcam mic rather than a plugged-in headset.
What a good result actually looks like
Three numbers describe a healthy microphone. Peaks between -12 dB and -6 dB, meaning you are loud enough without touching the ceiling. A noise floor below -50 dB, meaning the room is quiet when you are. Zero clipped frames, meaning nothing has been squared off and destroyed.
Miss any one of them and the fix is different. Low peaks mean move closer or raise the input volume. A high noise floor means the room, not the microphone, is your problem. Clipped frames mean you are too loud and no amount of processing will restore what was lost.
Questions people ask
Why does the browser ask for permission every time?
Some browsers only remember the choice for the session, and private or incognito windows always forget it. Allowing the site in your browser's site settings makes the choice permanent.
What is a good level?
Peaks between -12 dB and -6 dB, with a noise floor below -50 dB. That gives clean headroom without clipping.
The test works but people still cannot hear me
Then the microphone is fine and the app is not. Open that app's audio settings and select the same device you chose here.
Is my audio uploaded anywhere?
No. The test uses the Web Audio API inside your browser. Nothing is sent to a server, and recordings live in memory until you close the tab or download them yourself.
Related tests
Where to go next: the Windows guide, a plain browser mic test, or the main test console.
Tested and updated · Written and maintained by check-mic.com · Report a problem with this page